Two reasons for blocking of charging tower

The feed tower equipment is generally used in chicken farm, which provides great help for breeding. The feed tower line is the feed supply and transmission pipeline of feed tower, which is used for conveying and feed tank for livestock. Simple and easy feeding is the advantage of the feeding tower equipment, but there are also farmers who report that the feeding tower line is often blocked and the feed supply is not up. The following is the feeding tower manufacturer's answer for the farm.

 

Material tower

 

I. blockage reason: the blockage of the feeding tower may be caused by the problem of the electronic scale or the blockage of the feeding blanking cover and the feeding side.

 

1. Scale problems: (1) limit plug of scale metering tube. The material in the metering pipe is not transported smoothly or the material is piled up in the metering pipe for a long time, which makes it difficult to unload the material, resulting in the limit plug of the metering pipe. (2) the synchronous mechanical transmission system of the electronic scale and the feeding tower or the control of the electric DC speed regulating board has a running fault, resulting in the non synchronous feeding and blocking.

 

2. Blocking of feeding blanking cover and feeding side: during feeding operation, pay attention to observe the operation and stop the machine immediately if the blanking port is blocked. If the flow separation of the electronic scale fluctuates or there is no flow signal, the feeding failure of the tower system can be judged. This is caused by the improper adjustment of the photoelectric switch and the rake roller.

 

 

 

2. Exclusion method:

 

1. Check the working condition of the photocell, adjust the position of the photocell, readjust the gap between the rake roller and the lifting belt, and control the feeding height under the condition of ensuring the flow of the production line.

 

2. Repair the faulty parts of mechanical transmission system or electrical speed governing board to make the feeding tower and electronic scale run for 6 steps.

 

3. Open the maintenance observation window to check whether the blanking at the blanking opening is smooth, and carry out local transformation. Check whether the connection between the blanking port and the metering pipe is reasonable and whether the design angle of the chute of the hopper is correct.